Submit
  • Adhesives

Desmodur® T 80

2,4- and 2,6-toluene diisocyanate (TDI) in the ratio 80 : 20.As a raw material for polyurethane coatings and adhesives.

Contact an Expert
i
Market Switch
Selection will influence the results you get.
Copied to clipboard

About

Product Types

  • Isocyanate
  • TDI

Material

Adhesives
Solvent-free

General Characterization

2,4- and 2,6-toluene diisocyanate (TDI) in the ratio 80 : 20.
As a raw material for polyurethane coatings and adhesives.

Storage Conditions

- Storage in original sealed Covestro container.

- Recommended storage temperature: 18 - 40°C.

- Protect from moisture, heat and foreign material.

General information: The product is sensitive to moisture and heat. It should be protected against contact with atmospheric moisture. Higher storage temperatures for prolonged periods may result in discoloration or the formation of insoluble deposits. The product crystallizes partially or fully at temperatures below approx. 15 °C. However, careful melting at up to 50 °C will reliquify the product without any detrimental effect on its quality. A contact temperature of 80 °C must not be exceeded. The reliquified product must be homogenized as crystallization causes a shift in the isomer ratio between the crystalline and the still liquid phases. Opened containers must be resealed after removing product. If stored for long periods, the product should be overlaid with nitrogen. The product reacts with water to release carbon dioxide. During storage, transfer and handling of the product, contact with water in any form (damp containers, aqueous solvents, moist air) must be prevented as the generation of carbon dioxide may result in a dangerous increase in pressure. The polyureas which are formed at the same time may result in turbidity. They may also cause blockages and breakdowns in filters, pumps and pipes.

Sampling

No data available

Packaging Type

No data available

Technical Properties & Datasheets

Property Name Test Method Unit Value
Purity TDI-01-01 % ≥ 99.5
Content of 2,4'-TDI TDI-01-04 % 80.5 ± 1
Hydrolysable chlorine TDI-01-03 mg/kg ≤ 100
Acidity TDI-01-02 mg/kg ≤ 40

Property Name Test Method Unit Value
Density at 25 °C DIN 51 757 g/ml approx. 1.22
Flash point DIN EN ISO 2719 °C approx. 130
Viscosity at 25 °C DIN 53 015 mPa*s approx. 3
Boiling point (1 bar) °C approx. 250
Solidification point DIN 53 175 °C approx. 14
Isocyanate content (by degree of purity method) % ≥ 48

Downloads

Technical Data Sheet
Download
Safety Data Sheet
No direct download available, please visit www.productsafetyfirst.covestro.com
Download

Do you want to know more about Desmodur® T 80?
Get in touch with our experts!

Contact form image Zoe

How can we contact you?

* Mandatory Fields

1 product to compare